IOWA CITY MODERATED FORSALE NEWSGROUP > Tools
> Power Tools
> 2009
> Motion technologies kollmorgen dc servo gear motor cnc
Motion technologies kollmorgen dc servo gear motor cnc
Motion Technologies Kollmorgen
This motor is pulled from hard disk manufacturing equipment. It has four mounting hole on the face of the motor, the shaft is 0.5" in diameter and 1" long. I ran it with 1.5V to 20 Volt and there was no way I could stop it by hand, I do not know the ratio, but it runs with a very high torque.
Each motor comes with a pre mounted encoder, there are two types of encoder, although different, but I know for sure they are the same as far as pinout and spec, since both types were used on this system with the same controller.
Each item prchased in here is one piece less sitting in the landfill
Click here to checkout my other items for nice stuff in motion control, robotics, CNC, ... etc
4- Money orders: Money orders must be in US dollars and payable by US banks.
