IOWA CITY MODERATED FORSALE NEWSGROUP > Industrial Equipment
> (12)LM7812 voltage regulators on heatsinks,+12V,lm 7812
(12)LM7812 voltage regulators on heatsinks,+12V,lm 7812
(12) LM7812 VOLTAGE REGULATOR ICs on HEATSINKS,
+12 VDC, LM 7812 +12VDC VOLTAGE REGULATORS, T0-220
These are circuit clips (used voltage regulator ICs). I have sampled-tested them under 12-ohm loads and every single one tested 100% perfect (10% randomly selected sample). The LM7812 ICs are riveted to their heatsinks for a snug thermal connection, and were mounted with conductive paste. IC leads extend 1/4" beneath heatsink for insertion into PC boards, solderless breadboards and prototype boards (for easier board insertion, you can use wire cutters to cut ends of leads at a slant to point them). One wing of the heatsinks is bent from the normal 90 degree position to about 45 degrees so that clipping tool could get a clean, even flush cut, but is easily and quickly bent back without breaking using pliars. TO-220 heat sinks like these are expensive (much more expensive than the LM7812), and the cost of mounting voltage regulators on T0-220 heatsinks in time, effort and money is substantial, especially in quantity, so don't let this great deal get by you. Of course, if you need these expensive T0-220 heat sinks for some other T0-220 voltage regulators (e.g. LM7805, LM7815, LM7908, etc.), T0-220 power opamps (e.g. TIP120, TIP32, etc.), or other part, you can always easily drill, punch or grind off the rivets to replace the LM7812s.
NOTE: Later availability not guaranteed. LIMITED QUANTITY.
Seller listing codes: LD097, LR000-S00, LS000-R00, LS000-R00, MM000, CC000.
