IOWA CITY MODERATED FORSALE NEWSGROUP > Electronics
> Industrial Electronics
> Prototyping board for a picaxe-08 and 08M
Prototyping board for a picaxe-08 and 08M
Prototyping Board - Fully assembled. For use with a PICAXE 08 or 08M.
* DB9 Serial Connector. Use a straight through cable from PC COM Port.
* Uses the enhanced download circuitry with a Shottkey diode.
* Solder pads to connect wall power unit or battery clip. (7 to 14 VDC).
* 78L05 voltage regulator with LED
* All PICAXE terminals brought out to solder pads.
* +5VDC and GRD buses run the length of the board.
* Jumper on Pin0. Connect to serial port for downloading.
* All holes are on 0.1 inch spacing and all have solder pads.
* Overall dimensions: 3-3/16 in X 1-3/4 in.
These two photos illustrate how I work with the board. In this example, I am using a MAX6675 to measure temperature using a K-type thermocouple. As you can see there is more than enough protoboard space for other circuitry.
This is another example of an application by John Carter.
This listing does not include a PICAXE, serial cable or wall power unit.
I have the PICAXE-08M in another listing.
