IOWA CITY MODERATED FORSALE NEWSGROUP > Electronics
> Industrial Electronics
> New macom techalert 10 wear debris detection sensor
New macom techalert 10 wear debris detection sensor
This is a New Macom Techalert 10 Model TA10-000425 Wear Debri Detection Sensor. This item is new. Please email with questions and I will answer them to the best of my ability. This item is gauranteed to be in the described condition.
• Ferrous & Non-Ferrous Metallic debris detection
• Sensitivity down to 50µ for Ferrous debris
• Data split into 10 size ranges
The TechAlert 10 is an on-line inductive sensor designed to count and size both ferrous and non-ferrous wear debris in circulating oil lubrication systems. Metallic particles pass through the sensor causing changes in the inductance of a transducer coil. These changes appear as a frequency shift, allowing discrimination between ferrous and non-ferrous particles, while the signal amplitude indicates particle size and concentration. The data is then displayed in 10 size ‘ranges’ (5 ferrous, 5 non-ferrous) giving greater information to make better decisions. By having an idea of the size of debris it is possible to identify what type of wear/fault is occurring.
The unit uses a patented screening technique to eliminate any false counts caused by air or water bubbles in the lubricating oil system.
By creating a unique signature of the process equipment the TechAlert 10 will give the user early indications of component wear, giving time for pro active maintenance, reducing the risk of catastrophic failure, saving time and money as well as helping to effectively manage a valuable asset. A prime example of this can be found in our Airtricity Case Study.
Specification • Working pressure 0 to 10 bar gauge
• Fluid temperature 0°C to 90°C
• Fluid Mineral or synthetic oil
• Viscosity Viscosity independent
• Ambient Temperature 0°C to 100°C
• Data Processing Dual micro controllers
• Data interface * RS232, RS485, Ethernet
• Serial data 9600-BAUD, 8 bit, 1 stop & no parity
• Serial protocol * Modbus, SNAP with 16-bit CRC error detection
• Diagnostics Internal software self-diagnostics & self test
• Service No maintenance or calibration required
• Standards Enclosure IP66 rated
Meets BS EN60068-2-6 (vibration)
